-
- News
- Books
Featured Books
- design007 Magazine
Latest Issues
Current IssueCreating a Culture of Collaboration
PCB designers could learn quite a bit from NASA and the private companies that develop spacecraft: Every one of these vehicles is a testament to the value of collaboration among disparate stakeholders. Without a collaborative culture, the rocket might never get off the ground.
Breaking High-speed Material Constraints
Do you need specialty materials for your high-speed designs? Maybe not. Improvements in resins mean designers of high-speed boards can sometimes use traditional laminate systems. Learn more in this issue.
Level Up Your Design Skills
This month, our contributors discuss the PCB design classes available at IPC APEX EXPO 2024. As they explain, these courses cover everything from the basics of design through avoiding over-constraining high-speed boards, and so much more!
- Articles
- Columns
Search Console
- Links
- Events
||| MENU - design007 Magazine
Estimated reading time: 1 minute
Beyond Design: Transmission Line Termination
In a previous column “Beyond Design: Interconnect Impedance,” we saw that the impedance of the interconnect is the most critical factor in high-speed PCB design. Unfortunately, the source impedance of a digital IC driver is typically lower than the impedance of the transmission line (10–35 ohms). This is far from the ideal situation for the perfect transfer of energy, and, in most cases, results in reflections and electromagnetic radiation if not addressed.
Whenever a signal meets an impedance variation along a transmission line, there will be a reflection, which can seriously impact signal integrity. By understanding the causes of these reflections and eliminating the source of the mismatch, a design can be engineered with reliable performance. In this month’s column, I will look at how to effectively terminate transmission lines.
In an ideal world, the energy emanating from an IC output driver would travel through the PCB transmission line and be totally absorbed by the load. However, if energy is not completely absorbed, then the residual will be reflected back along the interconnect, reaching the original source of energy at the output driver. Reflected energy acts like a standing wave and adds or subtracts to the original signal, causing ringing. Resonance can develop at a signal’s fundamental frequency or harmonics resulting in multiple bounces and emission of radiation. This situation only occurs when the round-trip delay of the interconnect exceeds the signal rise time.
Even if the multilayer PCB has been designed with controlled impedance in mind, impedance discontinuities can still occur due to input gate capacitance, branches, stubs, or test pads; variations in dielectric materials; a neck-down in a via field; skew in a differential pair; or a gap in the return signal path. Generally, the reflected noise level should be kept below 10% of the voltage swing, but this depends on the noise budget. In more conservative designs, the noise budget may be as low as 5%.
There are numerous ways to terminate transmission lines, but the most common methods fall into three categories:
- Series termination
- End termination
- Differential pair termination
To read this entire column, which appeared in the March 2020 issue of Design007 Magazine, click here.
More Columns from Beyond Design
Beyond Design: Dielectric Material Selection GuideBeyond Design: The Art of Presenting PCB Design Courses
Beyond Design: Embedded Capacitance Material
Beyond Design: Return Path Optimization
Beyond Design: Just a Matter of Time
Beyond Design: Design Success with IPC Standards
Beyond Design: Integrating AI Into PCB Design Flow
Beyond Design: Standing Waves in Multilayer PCB Plane Cavities